Hi,
My workcenter 6515DNI broke the emmc-card when we had a power outage while print job was ongoing. Contacted xerox support that told me I have to buy the whole mainboard at a price twice the new printer. So I went on searching internet for a new/used emmc-card only.
Finally got one that was sold "as new" After installing it the printer came up with a message to restart after config restore.
But, then i was suprised by the fact that the printer now had changed to 6515N, with an other serialnr than label on backside, and pagecounter 10 times actually use. The restore had gone from emmc card to the mainboard instead of the other way as expected !?!?
It was obviously not an brand new emty emmc card i have bought, but a used one from an 6515N with duplex print disabled.
Contacted seller, that promised me a solution, but after many emails and waiting a long time, he stopped responding to me.
So, now i have a 6515DNI that only print on one side, regardless of what is set in the driver print settings in windows.
Is there a way to change/tweak/hack settings back to DN-mode?
My workcenter 6515DNI broke the emmc-card when we had a power outage while print job was ongoing. Contacted xerox support that told me I have to buy the whole mainboard at a price twice the new printer. So I went on searching internet for a new/used emmc-card only.
Finally got one that was sold "as new" After installing it the printer came up with a message to restart after config restore.
But, then i was suprised by the fact that the printer now had changed to 6515N, with an other serialnr than label on backside, and pagecounter 10 times actually use. The restore had gone from emmc card to the mainboard instead of the other way as expected !?!?
It was obviously not an brand new emty emmc card i have bought, but a used one from an 6515N with duplex print disabled.
Contacted seller, that promised me a solution, but after many emails and waiting a long time, he stopped responding to me.
So, now i have a 6515DNI that only print on one side, regardless of what is set in the driver print settings in windows.
Is there a way to change/tweak/hack settings back to DN-mode?