- Joined
- Mar 28, 2020
- Messages
- 1
The Ship I'm on has an HP DesignJet T1300, which would make our lives much easier if it worked
Printer will initialize to 26% then hang up and eventually give error 79.2:04. I have restarted the printer and left it unplugged overnight multiple times to no change, and attempting to start and access diagnostic mode has the same result.
I have tried rebooting with the ink cartridges and paper removed, but cannot access the print heads as the carriage is currently under the right side cover, once I find a T-15 screwdriver I'm going to get at it to try removing them.
I have also attempted a boot mode firmware update (using a 128GB USB 3.0 Flash drive, maybe too big?) which hung up around 86% during the system file check.
Anyone have any suggestions for next steps?
Edit: Error Code is 0xbabe0007
Printer will initialize to 26% then hang up and eventually give error 79.2:04. I have restarted the printer and left it unplugged overnight multiple times to no change, and attempting to start and access diagnostic mode has the same result.
I have tried rebooting with the ink cartridges and paper removed, but cannot access the print heads as the carriage is currently under the right side cover, once I find a T-15 screwdriver I'm going to get at it to try removing them.
I have also attempted a boot mode firmware update (using a 128GB USB 3.0 Flash drive, maybe too big?) which hung up around 86% during the system file check.
Anyone have any suggestions for next steps?
Edit: Error Code is 0xbabe0007
Last edited: