Reply to thread

Message: [QUOTE="Shplad, post: 228047, member: 22044"] Okay, I used a mixture of polyethlyene glycol, alcohol and distilled water. I injected it into the ink points and inserted a paper towel saturated with it under the head. That formula really took out a huge amount of dried ink on the jammed ink points. Within a few seconds, the formula went right through the ink points, with almost no pressure exerted. A lot of ink came off via the paper towel under the head too. However, I'm still getting next to zero black and very little yellow output. What's the best thing to do? Note that this is basically the same as what I was getting before I cleaned everything. I don't want to run another nozzle clean in the driver if possible, as it seems to use almost 1/4 tank to do it. And I'm already down to half a tank of black and yellow (again). Suggestions? [/QUOTE]